Jatontec JT4300M, Administrator User Manual

Page: 21 / 52

Page 21
6. Network Configuration

Operation Mode Setting
The default device Operation Mode is Router, and the PC connected to device LAN port will
obtain IP address via DHCP client.
The device operation mode could be changed from Router to Bridge if necessary as show by the
following diagram:
In Bridge mode, the PC which connected the LAN port of the CPE will obtain the IP directly from
the network. However, the device WEB GUI may still be accessed via port 8080 from remote side
if remote management is enabled. For local LAN access, the user or operator can configure LAN
PC with a static IP address as 172.16.1.x and login the WEB GUI via
http://172.16.1.1 .

LAN Networking
The LAN setting allows user to specify the device LAN IP, DHCP server setting, Local DNS and
etc. When Router mode is selected, the DHCP server should be enabled by default.
User is advised to leave the default setting unchanged for quick configuration and smooth device
operation.