AT-488
[RE5F22A]
DTC P0711 FLUID TEMPERATURE SENSOR PERFORMANCE
Revision: November 2006
2006 Altima
DTC P0711 FLUID TEMPERATURE SENSOR PERFORMANCE
PFP:31940
Description
ECS009E5
The A/T fluid temperature sensor detects the A/T fluid temperature and sends a signal to the TCM.
On Board Diagnosis Logic
ECS009E6
●
This is an OBD-II self-diagnostic item.
●
Diagnostic trouble code “FLUID TEMP SEN” with CONSULT-II or P0711 without CONSULT-II is detected
when ATF temperature signal does not change.
Possible Cause
ECS009E7
●
Harness or connectors
(The sensor circuit is open or shorted.)
●
A/T fluid temperature sensor
DTC Confirmation Procedure
ECS009E8
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC Confirmation Procedure” has been previously performed, always turn ignition switch “OFF”
and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
WITH CONSULT-II
1.
Turn ignition switch “ON”. (Do not start engine.)
2.
Select “A/T” with “DATA MONITOR” mode in CONSULT-II.
3.
Start engine.
4.
Drive vehicle and maintain the following conditions for at least
15 minutes (Total). (It is not necessary to maintain continuously.)
VHCL SPEED SE-A/T: 40 km/h (25 MPH) or more
SLCT LVR POSI: “D” position
5.
If DTC is detected, go to
AT-490, "Diagnostic Procedure"
.
WITH GST
Follow the procedure “With CONSULT-II”.
BCIA0030E