AT-478
[RE5F22A]
DTC P0705 PARK/NEUTRAL POSITION SWITCH
Revision: November 2006
2006 Altima
DTC P0705 PARK/NEUTRAL POSITION SWITCH
PFP:32006
Description
ECS009DR
●
The park/neutral position (PNP) switch includes a transmission position switch.
●
The transmission range switch detects the selector lever position and sends a signal to the TCM.
●
TCM judges the selector lever position by the park/neutral position (PNP) switch signal.
On Board Diagnosis Logic
ECS009DS
●
This is an OBD-II self-diagnostic item.
●
Diagnostic trouble code “PNP SW/CIRC” with CONSULT-II or P0705 without CONSULT-II is detected
when PNP switch signals input with impossible pattern.
Possible Cause
ECS009DT
●
Harness or connectors
[The park/neutral position (PNP) switch and TCM circuit is open or shorted.]
●
Park/neutral position (PNP) switch
DTC Confirmation Procedure
ECS009DU
NOTE:
If “DTC Confirmation Procedure” has been previously performed, always turn ignition switch “OFF”
and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
WITH CONSULT-II
1.
Turn ignition switch “ON”. (Do not start engine.)
2.
Select “A/T” with “DATA MONITOR” mode in CONSULT-II.
3.
Move selector lever to each position.
SLCT LVR POSI: “P”, “R”, “N” or “D” position
4.
Wait for at least 5 consecutive seconds at each position.
5.
If DTC is detected, go to
AT-480, "Diagnostic Procedure"
.
WITH GST
Follow the procedure “With CONSULT-II”.
Selector lever
PNP switch A
PNP switch B
PNP switch C
PNP switch PA
PNP switch PN
P
ON
OFF
OFF
ON
ON
R
ON
ON
OFF
OFF
OFF
N
OFF
ON
OFF
ON
ON
D
OFF
ON
ON
OFF
OFF
BCIA0030E
