AT-476
[RE5F22A]
DTC P0613 TCM PROCESSOR
Revision: November 2006
2006 Altima
DTC P0613 TCM PROCESSOR
PFP:31036
Description
ECS009DM
The TCM consists of a microcomputer and connectors for signal
input and output and for power supply. The TCM controls the A/T.
On Board Diagnosis Logic
ECS009DN
●
This is not an OBD-II self-diagnostic item.
●
Diagnostic trouble code “TCM PROCESSOR” with CONSULT-II is detected when TCM processor is mal-
functioning.
Possible Cause
ECS009DO
TCM
DTC Confirmation Procedure
ECS009DP
NOTE:
If “DTC Confirmation Procedure” has been previously performed, always turn ignition switch “OFF”
and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
WITH CONSULT-II
1.
Turn ignition switch “ON”. (Do not start engine.)
2.
Select “A/T” with “DATA MONITOR” mode in CONSULT-II.
3.
Start engine.
4.
Run engine for at least 2 consecutive seconds at idle speed.
5.
If DTC is detected, go to
AT-477, "Diagnostic Procedure"
.
SCIA2820E
BCIA0030E