AT-474
[RE5F22A]
DTC P0500 VEHICLE SPEED SENSOR MTR
Revision: November 2006
2006 Altima
DTC P0500 VEHICLE SPEED SENSOR MTR
PFP:24814
Description
ECS009DH
The vehicle speed sensor·MTR signal is transmitted from unified meter and A/C amp. to TCM by CAN commu-
nication line. The signal functions as an auxiliary device to the revolution sensor when it is malfunctioning. The
TCM will then use the vehicle speed sensor·MTR signal.
On Board Diagnosis Logic
ECS009DI
●
This is not an OBD-II self-diagnostic item.
●
Diagnostic trouble code “VEH SPD SE/CIR-MTR” with CONSULT-II or 15th judgement flicker without
CONSULT-II is detected when TCM does not receive the proper vehicle speed sensor MTR signal (input
by CAN communication) from unified meter and A/C amp.
Possible Cause
ECS009DJ
●
Harness or connectors
(The signal circuit is open or shorted.)
●
Unified meter and A/C amp.
●
ABS actuator and electric unit (control unit)
●
Wheel sensor
DTC Confirmation Procedure
ECS009DK
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC Confirmation Procedure” has been previously performed, always turn ignition switch “OFF”
and wait at least 10 seconds before performing the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
WITH CONSULT-II
1.
Turn ignition switch “ON” and select “DATA MONITOR” mode for
“A/T” with CONSULT-II.
2.
Start engine.
3.
Drive vehicle and maintain the following conditions for at least 5
consecutive seconds.
VHCL/S SE-A/T: 30 km/h (17 MPH) or more
ACCELE ANGLE: 10 % or less
4.
If DTC is detected, go to
AT-475, "Diagnostic Procedure"
.
BCIA0030E