Jatco RE4F04B, Manual, Page: 390 / 708

AT-390
[RE5F22A]
PRECAUTIONS
Revision: November 2006 2006 Altima
Precautions for A/T Assembly or TCM Replacement
ECS009CA
●
When replacing A/T assembly or TCM, refer to the pattern table below and initialize TCM if necessary.
TCM INITIALIZATION PATTERNS
NOTE:
“Old one” is the TCM or A/T assembly that has been used on other vehicles.
METHOD FOR TCM INITIALIZATION
1. Perform “CONSULT-II SETTING PROCEDURE”. Refer to AT-462, "CONSULT-II SETTING PROCE-
DURE" .
2. Set the vehicle following the items listed below.
●
Ignition switch “ON”.
●
Selector lever “P” or “N” position.
●
Engine not running.
●
Vehicle speed is 0 km/h (0 MPH).
●
Ignition voltage is more than 10.5V.
●
Malfunction was not detected.
3. Touch “WORK SUPPORT”.
4. Touch “INITIALIZATION”.
5. Initialize TCM following the direction in display.
TCM A/T assembly Erasing EEPROM in TCM Remarks
Replaced with
new one
Not replaced
Not required
Not required because the EEPROM in TCM is in the default
state.
Replaced with
new or old one
Not replaced
Replaced with
new or old one
Required
Required because data cannot be conformed to previous
data written in the EEPROM in TCM.
Replaced with
old one
Not replaced
Replaced with
new or old one