DTC P1760 OVERRUN CLUTCH SOLENOID VALVE
AT-185
[RE4F04B]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
DTC P1760 OVERRUN CLUTCH SOLENOID VALVE
PFP:31940
Description
ECS0098U
The overrun clutch solenoid valve is activated by the TCM in
response to signals sent from the park/neutral position (PNP) switch,
overdrive control switch, vehicle speed and ECM (throttle opening).
The overrun clutch operation will then be controlled.
On Board Diagnosis Logic
ECS0098V
Diagnostic trouble code O/R CLTCH SOL/CIRC with CONSULT-II or P1760 without CONSULT-II is detected
when TCM detects an improper voltage drop when it tries to operate the solenoid valve.
Possible Cause
ECS0098W
Check the following items.
●
Harness or connectors
(The solenoid circuit is open or shorted.)
●
Overrun clutch solenoid valve
Diagnostic Trouble Code (DTC) Confirmation Procedure
ECS0098X
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE” has been previously conducted, always
turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
TESTING CONDITION:
Always drive vehicle on a level road to improve accuracy of test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
WITH CONSULT-II
1.
Turn ignition switch ON and select “DATA MONITOR” mode for
“A/T” with CONSULT-II.
2.
Touch "MAIN SIGNALS".
Touch "START".
3.
Start engine.
4.
Accelerate vehicle to a speed of more than 10 km/h (6 MPH)
with selector lever in D position.
SAT283HB
BCIA0030E
