AT-182
[RE4F04B]
DTC P1705 THROTTLE POSITION SENSOR [ACCELERATOR PEDAL POSI-
TION (APP) SENSOR]
Revision: November 2006
2006 Altima
DTC P1705 THROTTLE POSITION SENSOR [ACCELERATOR PEDAL POSITION
(APP) SENSOR]
PFP:22560
Description
ECS0098O
Electric throttle control actuator consists of throttle control motor,
accelerator pedal position sensor, throttle position sensor, etc. The
actuator sends signals to the ECM, and ECM sends signals to TCM
via CAN communication.
CONSULT-II REFERENCE VALUE IN DATA MONITOR MODE
Remarks: Specification data are reference values.
On Board Diagnosis Logic
ECS0098P
This is an OBD self-diagnostic item.
Diagnostic trouble code "P1705 THROTTLE POSI SEN" with CONSULT-II or 3rd judgement flicker without
CONSULT-II is detected when TCM does not receive the proper accelerator pedal position signals (input via
CAN communication from ECM.
Possible Cause
ECS0098Q
Harness or connectors
(The sensor circuit is open or shorted.)
Diagnostic Trouble Code (DTC) Confirmation Procedure
ECS0098R
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC Confirmation Procedure” has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
WITH CONSULT-II
1.
Turn ignition switch ON and select “DATA MONITOR” mode for
“A/T” with CONSULT-II.
2.
Depress accelerator pedal fully and release it, then wait for 5
seconds.
3.
If DTC is detected, go to
AT-183, "Diagnostic Procedure"
.
WITH GST
Follow the procedure “With CONSULT-II”.
LCIA0067E
Monitor item
Condition
Specification
THROTTLE POSI
Released accelerator pedal
0.0/8
Fully depressed accelerator pedal
8.0/8
BCIA0031E
