AT-120
[RE4F04B]
DTC P0710 A/T FLUID TEMPERATURE SENSOR CIRCUIT
Revision: November 2006
2006 Altima
Diagnostic Procedure
ECS0096T
1.
INSPECTION START
Do you have CONSULT-II?
Yes or No
Yes
>> GO TO 2.
No
>> GO TO 6.
2.
CHECK INPUT SIGNAL OF A/T FLUID TEMPERATURE SENSOR (WITH CONSULT-II)
With CONSULT-II
1.
Start engine.
2.
Select “TCM INPUT SIGNALS” in “DATA MONITOR” mode for “A/T” with CONSULT-II.
3.
Read out the value of “FLUID TEMP SE”.
OK or NG
OK
>> GO TO 7.
NG
>> GO TO 3.
3.
CHECK A/T FLUID TEMPERATURE SENSOR WITH TERMINAL CORD ASSEMBLY
1.
Turn ignition switch to OFF position.
2.
Disconnect terminal cord assembly connector in engine compartment.
3.
Check resistance between terminal cord F30 terminals 6 and 7
(component side) when A/T is cold.
4.
Reinstall any part removed.
OK or NG
OK
>> GO TO 4.
NG
>> GO TO 5.
4.
DETECT MALFUNCTIONING ITEM
Check the following items:
●
Harness for short to ground or short to power or open between TCM, ECM and terminal cord assembly
(Main harness)
●
Ground circuit for ECM
Refer to
PG-4, "POWER SUPPLY ROUTING CIRCUIT"
.
OK or NG
OK
>> GO TO 7.
NG
>> Repair or replace damaged parts.
Voltage
:Cold [20
°
C (68
°
F)]
→
Hot [80
°
C (176
°
F)]
:Approximately 1.5V
→
0.5V
LCIA0090E
Temperature
Resistance (Approx.)
Cold [20
°
C (68
°
F)]
2.5k
Ω
WCIA0097E
