AT-74
[RE4F04B]
TROUBLE DIAGNOSIS - BASIC INSPECTION
Revision: November 2006
2006 Altima
b.
If one or more pieces of debris are found that are over 1mm in
size and/or peeled clutch facing material is found in the coffee
filter, the fluid cooler is not serviceable. The radiator/fluid cooler
must be replaced and the inspection procedure is ended.
A/T FLUID COOLER FINAL INSPECTION
After performing all procedures, ensure that all remaining oil is cleaned from all components.
Stall Test
ECS0096A
STALL TEST PROCEDURE
1.
Check A/T fluid and engine oil levels. If necessary, add fluid and
oil.
2.
Drive vehicle for approximately 10 minutes or until fluid and oil reach operating temperature.
3.
Set parking brake and block wheels.
4.
Install a tachometer where it can be seen by driver during test.
●
It is good practice to mark the point of specified engine
rpm on indicator.
5.
Start engine, apply foot brake, and place selector lever in D
position.
6.
Accelerate to wide open throttle gradually while applying foot
brake.
7.
Quickly note the engine stall revolution and immediately release
throttle.
●
During test, never hold throttle wide open for more than 5
seconds.
SCIA2971E
SAT647B
ATF operating temperature
:50 - 80
°
C (122 - 176
°
F)
SAT513G
Stall revolution
: 2,300 - 2,750 rpm
SAT514G
