AT-590
[RE5F22A]
DTC P0826 MANUAL MODE SWITCH CIRCUIT
Revision: November 2006
2006 Altima
2.
CHECK HARNESS BETWEEN TCM AND A/T DEVICE (MANUAL MODE SWITCH)
1.
Turn ignition switch “OFF”.
2.
Disconnect the TCM connector.
3.
Check the continuity between TCM connector terminals 5, 6, 16,
19 and ground.
4.
If OK, check harness for short-circuit to ground or power source.
OK or NG
OK >> GO
TO
4.
NG
>> GO TO 3.
3.
DETECT MALFUNCTIONING ITEM
Check the following.
●
Open or short-circuit in the harness between TCM and A/T device (manual mode switch).
●
Open or short-circuit in the harness for ground of manual mode switch.
●
AT-591, "Component Inspection"
.
OK or NG
OK
>> GO TO 4.
NG
>> Repair or replace damaged parts.
4.
CHECK DTC
Perform “DTC Confirmation Procedure”. Refer to
AT-586, "DTC Confirmation Procedure"
.
OK or NG
OK
>> INSPECTION END
NG
>> GO TO 5.
5.
CHECK TCM
1.
Check TCM input/output signal. Refer to
AT-459, "TCM Input/Output Signal Reference Values"
2.
If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK
>> INSPECTION END
NG
>> Repair or replace damaged parts.
Connector
No.
Terminal
Condition
Continuity
F56
5 - Ground
Selector lever: + side
Yes
Other than the above
No
6 - Ground
Selector lever: - side
Yes
Other than the above
No
16 - Ground
Selector lever: “P”, “R”, “N” or “D” posi-
tion
Yes
Selector lever: Manual shift gate posi-
tion
No
19 - Ground
Selector lever: Manual shift gate posi-
tion (neutral)
Yes
Other than the above
No
SCIA2919E
