AT-534
[RE5F22A]
DTC P0745 PRESSURE CONTROL SOLENOID VALVE A (LINE PRESSURE)
Revision: November 2006
2006 Altima
TCM terminals and data are reference value. Measured between each terminal and ground.
Diagnostic Procedure
ECS009G0
1.
CHECK PRESSURE CONTROL SOLENOID VALVE A SIGNAL
With CONSULT-II
1.
After warming up the engine and transaxle, turn ignition switch “OFF”.
2.
Turn ignition switch “ON”. (Do not start engine.)
3.
Select “DATA MONITOR” mode for “A/T” with CONSULT-II.
4.
Read out the value of “PC SOL A OUT” and “PC SOL A MON”.
Without CONSULT-II
1.
Start the engine.
2.
Check pulse between TCM connector terminals 35 and 40.
OK or NG
OK >> GO
TO
7.
NG
>> GO TO 2.
2.
CHECK PRESSURE CONTROL SOLENOID VALVE A CIRCUIT
1.
Turn ignition switch “OFF”.
2.
Disconnect the TCM connector.
3.
Check resistance between TCM connector terminals 35 and 40.
OK or NG
OK
>> GO TO 7.
NG
>> GO TO 3.
Terminal
Wire
color
Item
Condition
Data (Approx.)
35
L/Y
Pressure control
solenoid valve A
When engine is running with idle speed and set-
ting selector lever to “P” position.
300Hz
40
L/G
Pressure control
solenoid valve A
ground
When engine is running with idle speed and set-
ting selector lever to “P” position.
0V
Monitor item
Condition
Display value
(Approx.)
●
PC SOL A OUT
●
PC SOL A MON
When releasing accelerator pedal with set-
ting selector lever to “P” position.
1.00 A
When depressing accelerator pedal fully set-
ting selector lever to “P” position.
0.32 A
SCIA2907E
Connector
Terminal
Condition
Data
(Approx.)
F57
35 - 40
When engine is running with idle
speed and setting selector lever to
“P” position.
300 Hz
SCIA2908E
Connector
Terminal
Condition
Resistance
(Approx.)
F57
35 - 40
Temperature: 20
°
C (68
°
F)
5.0 - 5.6
Ω
SCIA2909E