DTC P0705 PARK/NEUTRAL POSITION SWITCH
AT-481
[RE5F22A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
2.
CHECK PNP SWITCH POWER SOURCE CIRCUIT
1.
Turn ignition switch “OFF”.
2.
Disconnect the PNP switch connector.
3.
Turn ignition switch “ON”. (Do not start engine.)
4.
Check voltage between PNP switch connector terminals 2, 5
and ground.
5.
Turn ignition switch “OFF”.
6.
Check voltage between PNP switch connector terminals 2, 5
and ground.
7.
If OK, check harness for short-circuit to ground or power source.
OK or NG
OK >> GO
TO
3.
NG
>> Check the following. If any items are damaged, repair or replace damaged parts.
●
Harness for short or open between ignition switch and PNP switch
●
Ignition switch and fuse
Refer to
PG-4, "POWER SUPPLY ROUTING CIRCUIT"
3.
CHECK HARNESS BETWEEN TCM AND PNP SWITCH
1.
Turn ignition switch “OFF”.
2.
Disconnect the TCM connector and PNP switch connector.
3.
Check continuity between TCM connector terminals 24, 31, 32,
43 and ground.
4.
If OK, check the following.
–
Harness for short-circuit to ground or power source.
–
Open or short-circuit in the harness between combination meter and TCM.
OK or NG
OK >> GO
TO
5.
NG
>> GO TO 4.
Connector
Terminal
Voltage
F29
2 - Ground
Battery voltage
5 - Ground
Connector
Terminal (Wire color)
Voltage
F29
2 - Ground
0V
5 - Ground
SCIA2869E
Connector
Terminal
Condition
Continuity
F57
24 - Ground
Selector lever: “P” and “R” position
Yes
Other than the above
No
31 - Ground
Selector lever: “R”, “N”, “D” and
manual mode position
Yes
Other than the above
No
32 - Ground
Selector lever: “D” and manual
mode position
Yes
Other than the above
No
43 - Ground
Selector lever: “P” and “N” position
Yes
Other than the above
No
SCIA2827E