PRECAUTIONS
AT-391
[RE5F22A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
Precautions
ECS009CB
●
Before connecting or disconnecting the TCM harness con-
nector, turn ignition switch “OFF” and disconnect negative
battery cable. Because battery voltage is applied to TCM
even if ignition switch is turned “OFF”.
●
When connecting or disconnecting pin connectors into or
from TCM, take care not to damage pin terminals (bend or
break).
Make sure that there are not any bends or breaks on TCM
pin terminal, when connecting pin connectors.
●
Before replacing TCM, perform TCM input/output signal
inspection and make sure whether TCM functions properly
or not.
AT-460, "TCM INSPECTION TABLE"
●
After performing each TROUBLE DIAGNOSIS, perform
“DTC (Diagnostic Trouble Code) CONFIRMATION PROCE-
DURE”.
The DTC should not be displayed in the “DTC CONFIRMA-
TION PROCEDURE” if the repair is completed.
●
Always use the specified brand of A/T fluid. Refer to
MA-12, "Fluids and Lubricants"
●
Use paper rags not cloth rags during work.
●
After replacing the A/T fluid, dispose of the waste oil using the methods prescribed by law, ordinance, etc.
●
Before proceeding with disassembly, thoroughly clean the outside of the transaxle. It is important to pre-
vent the internal parts from becoming contaminated by dirt or other foreign matter.
●
Disassembly should be done in a clean work area.
SEF289H
SEF291H
MEF040DA
SEF217U
