Jatco RE4F04B, Manual, Page: 376 / 708

AT-376
[RE4F04B]
ASSEMBLY
Revision: November 2006 2006 Altima
18. Install oil pan.
a.
Attach a magnet to oil pan.
b. Install new oil pan gasket on transaxle case.
c. Install oil pan on transaxle case.
CAUTION:
●
Do not reuse oil pan bolts as they are self-sealing bolts.
●
Tighten four bolts in a crisscross pattern to prevent dislo-
cation of gasket.
d. Tighten oil pan bolts and drain plug to the specified torque.
Refer to
AT-278, "Components" .
19. Install park/neutral position (PNP) switch.
a. Set manual shaft in P position.
b. Temporarily install PNP switch on manual shaft.
c. Move selector lever to N position.
d. Use a 4 mm (0.16 in) pin for this adjustment.
i. Insert the pin straight into the manual shaft adjustment hole.
ii. Rotate PNP switch until the pin can also be inserted straight into
hole in PNP switch.
e. Tighten PNP switch bolts. Refer to AT-278, "Components" .
f. Remove pin from adjustment hole after adjusting PNP switch.
20. Install A/T fluid charging pipe and fluid cooler tube with new O-
rings and new washers to transaxle case. Tighten A/T fluid
charging pipe and fluid cooler tube bolts to the specified torque.
Refer to
AT-278, "Components" .
CAUTION:
Do not reuse O-rings and copper washers.
21. Install torque converter.
a. Pour ATF into torque converter.
CAUTION:
●
Approximately 1 liter (1-1/8 US qt, 7/8 Imp qt) of fluid is
required for a new torque converter.
●
When reusing old torque converter, add the same amount
of fluid as was drained.
SAT003F
SCIA3154E
SCIA3622E
SAT768J
SAT428DA