AT-370
[RE4F04B]
ASSEMBLY
Revision: November 2006
2006 Altima
c.
With needle bearing installed on high clutch drum, place Tool
legs on machined surface of transaxle case (with gasket). Then
allow plunger to rest on needle bearing.
d.
Measure gap between cylinder and plunger. This measurement
should give exact total end play.
●
If end play is out of specification, decrease or increase thick-
ness of bearing race as necessary.
2.
Adjust reverse clutch drum end play “T
2
”.
a.
Place Tool on machined surface of transaxle case (with gasket).
Then allow gauging cylinder to rest on reverse clutch drum. Lock
cylinder in place with set screw.
b.
Install gauging plunger into cylinder, using Tool.
Total end play “T
1
”
: 0.25 - 0.55 mm
(0.0098 - 0.0217 in)
Available bearing race
for adjusting total end
play
: Refer to
ING RACE FOR ADJUST-
ING TOTAL END PLAY"
.
SAT216F
SAT218F
Tool number
:
—
(J-34291)
WCIA0379E
Tool number
:
—
(J-34290-6)
WCIA0380E