DTC P0732 A/T 2ND GEAR FUNCTION
AT-137
[RE4F04B]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006
2006 Altima
WITH CONSULT-II
1.
Start engine and select “DATA MONITOR” mode for “A/T” with
CONSULT-II.
2.
Make sure that output voltage of A/T fluid temperature sensor is
within the range below.
FLUID TEMP SEN: 0.4 - 1.5V
If out of range, drive the vehicle to decrease the voltage (warm
up the fluid) or stop engine to increase the voltage (cool down
the fluid).
3.
Select “2ND GR FNCTN P0732” of “DTC WORK SUPPORT”
mode for “A/T” with CONSULT-II and touch “START”.
4.
Accelerate vehicle to 45 to 50 km/h (28 to 31 MPH) under the
following condition and release the accelerator pedal com-
pletely.
THROTTLE POSI: Less than 1.0/8
Selector lever: D position
–
Check that “GEAR” shows “3” or “4” after releasing pedal.
5.
Depress accelerator pedal to WOT (more than 7.0/8 of “THROT-
TLE POSI”) quickly from a speed of 45 to 50 km/h (28 to 31
MPH) until “TESTING” changes to “STOP VEHICLE” or “COM-
PLETE”. (It will take approximately 3 seconds.)
If the check result NG appears on CONSULT-II screen, go to
.
If “STOP VEHICLE” appears on CONSULT-II screen, go to fol-
lowing step.
–
Check that “GEAR” shows “2” when depressing accelera-
tor pedal to WOT.
–
If “TESTING” does not appear on CONSULT-II for a long
time, select “SELF-DIAG RESULTS” for “ENGINE”. In case a
1st trip DTC other than P0732 is shown, refer to applicable
“TROUBLE DIAGNOSIS FOR DTC”.
6.
Stop vehicle.
7.
Follow the instruction displayed. (Check for normal shifting refer-
ring to the table below.)
8.
Make sure that “OK” is displayed. (If “NG” is displayed, refer to “DIAGNOSTIC PROCEDURE”.)
Refer to
AT-139, "Diagnostic Procedure"
WITH GST
Follow the procedure “With CONSULT-II”.
BCIA0030E
Vehicle condition
Gear on actual transaxle shift pattern when
screen is changed to 1
→
2
→
3
→
4
No malfunction exists
1
→
2
→
3
→
4
Malfunction for P0732 exists.
4
→
3
→
3
→
4
BCIA0031E
SAT021J