AT-116
[RE4F04B]
DTC P0710 A/T FLUID TEMPERATURE SENSOR CIRCUIT
Revision: November 2006
2006 Altima
DTC P0710 A/T FLUID TEMPERATURE SENSOR CIRCUIT
PFP:31940
Description
ECS0096O
The A/T fluid temperature sensor detects the A/T fluid temperature
and sends a signal to the TCM.
CONSULT-II REFERENCE VALUE IN DATA MONITOR MODE
Remarks: Specification data are reference values.
On Board Diagnosis Logic
ECS0096P
Diagnostic trouble code ATF TEMP SEN/CIRC with CONSULT-II or P0710 without CONSULT-II is detected
when TCM receives an excessively low or high voltage from the sensor.
Possible Cause
ECS0096Q
Check the following items.
●
Harness or connectors
(The sensor circuit is open or shorted.)
●
A/T fluid temperature sensor
Diagnostic Trouble Code (DTC) Confirmation Procedure
ECS0096R
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC Confirmation Procedure” has been previously conducted, always turn ignition switch OFF and wait at
least 10 seconds before conducting the next test.
After the repair, perform the following procedure to confirm the malfunction is eliminated.
SAT283HB
SAT021J
Monitor item
Condition
Specification (Approximately)
A/T fluid temperature sensor
Cold [20
°
C (68
°
F)]
↓
Hot [80
°
C (176
°
F)]
1.5V
↓
0.5V
2.5 k
Ω
↓
0.3 k
Ω
