Jasic EVOLVE200 PLUS, User Manual, Page: 49 / 62

EVOLVE200 PLUS USER MANUAL
47
5. Alarms of the machine and troubleshooting
ALARM
CODE ALARM ( description in
the cloud)
USER INFORMATIONS
DESCRIPTION
(front display
message)
Proposed action (cloud message) Possible reason (cloud message)
1
EXCEEDING INTERNAL
VOLTAGE LIMITS
Critical supply
voltage in the
main control
board.
1. Try to restart the machine. 2.
If the problem still exists then contact the
service center
THE MAIN CONTROL BOARD FAULT
2
BACKUP VOLTAGE
FAILURE BACKUP VOLTAGE
FAILURE
1. Try to restart the machine. 2.
If the problem still exists then contact the
service center
Low battey
3 HIGH CPU TEMPERATURE
The CPU
temperature is to
high.
1. Power off the machine and wait a few
minites to cool it down the CPU. 2. If
the problem still exists then contact the
service center.
HIGH AMBIENT TEMPERATURE
10
ERROR IN THE UNIQUE
IDENTIFIER
ERROR IN THE
UNIQUE
IDENTIFIER 1. Try to restart the machine. 2.
If the problem still exists then contact the
service center
1. Fault in the main control board.
2. Bad electrical connection.
11 ALARM 24V
The power supply
outside the limits
of 24V DC. 1. Try to restart the machine. 2.
If the problem still exists then contact the
service center
CONTROL BOARD FAULT
SUPPLY BOARD FAULT
12 ALARM 5V
The power supply
outside the limits
of 5V DC. 1. Try to restart the machine. 2.
If the problem still exists then contact the
service center
CONTROL BOARD FAULT
SUPPLY BOARD FAULT
13 ALARM -15V
The power supply
outside the limits
of -15V DC. 1. Try to restart the machine. 2.
If the problem still exists then contact the
service center
CONTROL BOARD FAULT
SUPPLY BOARD FAULT
14 ALARM +15V
The power supply
outside the limits
of +15V DC. 1. Try to restart the machine. 2.
If the problem still exists then contact the
service center
CONTROL BOARD FAULT
SUPPLY BOARD FAULT
15 HALL SENSOR
anomaly in the
read out in the
output current 1. Try to restart the machine. 2.
If the problem still exists then contact the
service center
1. Bad electrical connection.
2. Fault in the main control board
17
INTERNAL MEMORY
FAILURE
Memory anomaly.
1. Try to restart the machine. 2.
If the problem still exists then contact the
service center
1. Problem with the machine firmware
18
ERROR IN DC BUS
VOLTAGE
main inverter
supply voltage
anomaly 1. Try to restart the machine. 2.
If the problem still exists then contact the
service center
1. Main power supply board fault.
20 HIGH PROBE VOLTAGE
output voltage
anomaly
1. Try to restart the machine. 2.
If the problem still exists then contact the
service center
1. Main power supply fault
2. Fault in the main control board
21 UNKNOWN FUNCTION
selected program
is not available 1. Contact your dealer or visit the cloud to
add additional welding programs
1. No abilitations.
22
FRONT PANNEL DISPLAY
ERROR
front pannel error
1. Try to restart the machine. 2.
If the problem still exists then contact the
service center
CONTROL BOARD FAULT
FRONT PANEL FAULT
23 ANALOG TO DIGITAL Internal error in 1. Try to restart the machine. 2. CONTROL BOARD FAULT