Janome Memory Craft 550E, Instruction Book

Page: 15 / 84

13
b
Raise the threader slowly so a loop of the thread is
pulled up through the needle eye.
v
Pull down the needle threader knob as far as it will go.
Built-in Needle Threader
z
c
Pull the thread up and slip it between the thread cutter
and face plate from behind.
Pull the thread toward you to cut.
q
w
z
Press the lockout key to lock the machine.
Lower the presser foot.
Turn the handwheel toward you until the needle thread
sign
w
appears on the right upper corner of the
lockout window.
q
Lockout key
w
Needle thread sign
x
Pull the thread up to the left, over the needle threader
guide while holding the thread near the spool with
your hand.
e
Needle threader guide
r
Slit
NOTE:
The needle threader can be used with a #11 to #14
needle.
Thread size 50 to 90 is recommended.
Do not use thread size 30 or thicker.
NOTE:
Be sure that the thread pass the slit
r
of the needle
threader as shown.
NOTE:
If the thread is caught in the hook and the thread loop
is not formed, remove the thread from the hook and
pull it to take the thread end out through the needle
eye.
n
Pull the thread loop to take the thread end out through
the needle eye to the rear.
x
e
r
c
v
b
n