Janome HORIZON Memory Craft 9480 QC PROFESSIONAL, Instruction Book, Page: 12 / 164

10
Adjusting the Thread Cutter Switch Position
Placing the thread cutter switch to the left.
The thread cutter switch position can be adjusted for your
convenience.
If you wish to attach the thread cutter switch to the left
side of the foot control, follow the procedure below.
(3)
(2)
(3)
(1)
(1)
(2)
(1)
(1)
1.
2.
3.
1. Remove the setscrews A, B and washers with a
screwdriver.
(1) Setscrew A
(2) Setscrew B
(3) Washer
3. Attach the foot control and thread cutter switch
with the setscrews and the washers. Tighten the
setscrews A and B. Be sure that the cable is not
caught between the foot control and the base plate.
(1) Setscrew A
(2) Setscrew B
(3) Washer
(6)
(5)
(4)
(4)
Foot Control and Thread Cutter Switch
To attach the foot control and the thread cutter switch
to the base plate, tighten setscrews, and setscrews with
washers as shown.
(1) Foot control
(2) Thread cutter switch
(3) Base plate
(4) Setscrew A
(5) Setscrew B
(6) Washer
(1)
(2)
(3)
NOTE:
A Phillips head screwdriver is not included with this
machine.
2. Turn the base plate 180 degrees.