www.janitza.de
43
UMG 96-PA / UMG 96-PA-MID / UMG 96-PA-MID+
Fig.
Colors window
the phase to be set and confirm with button 6
(
Enter
).
·The selected color is shown framed in blue.
·Use buttons 3 (
) and 4 (
) to select the de-
sired color and confirm with button 6 (
Enter
) or
end the action with button 1 (
Esc
).
·To return to the measuring display
Home
, press
button 1 three times (
Esc
) and then press button
2 (
Home
).
12.6 System
In the
System
window, the user of the measure-
ment device can:
·View device-specific system settings.
·Configure a password.
·Delete or reset measured values and device
parameters.
·Open the
Configuration
window as previously
described.
·Use buttons 3 (
) and 4 (
) to select the item
System
and confirm with button 6 (
Enter
).
Fig.
Configuration window with the System item
activated.
Fig.
System window
·The
System
window appears.
1
2
3
4
5
1
Firmware version
2
Serial number of the measurement device
3
Date/time
4
Password function
5
Reset function
12.6.1 Firmware/Serial number
The firmware and the serial number of the mea-
surement device are required for support requests
or registration on the homepage (www.janitza.de).
12.6.2 Date/time
Setting the date and time. You can change the
settings for synchronization, the date and time
zones via
·the GridVis
®
software or
·the Modbus addresses
(see section „14.12 Time synchronization“ on
page 77).
12.6.3 Password
Use a password to block access to the config-
uration. The device can only be configured after
entering the password.
The password consists of a number combination
of up to 5 digits.
Setting ranges (devices
without
MID):
·
1-99999 = with password
·
00000
= without password
Default value:
·
00000
= without password
The UMG 96-PA is delivered ex works with the
password 00000 (no password) configured.
