JPC 100-WEB
www.janitza.de
20
8.
Alarming
Fig. 23: List of the current alarms
You can use the JPC 100-WEB to configure
warnings and alarms for the measured values
of the connected master and slave devices
(section 9. 3. on page 26).
All warnings and alarms are displayed in the
alarm list found in the
Alarming
menu.
Current alarms must be acknowledged. You
can either acknowledge all alarms at once by
pressing the
Acknowledge All
button or ac-
knowledge individual alarms by pressing the
check mark after the corresponding alarm.
Use the
Historic Alarms
button to open a list
of all alarms that are no longer current and
have been acknowledged.
The
Status
column shows you the status of
the corresponding alarm at a glance.
Fig. 24: Alarm status symbol explanation
Alarm/warning threshold is
currently over/undershot
Alarm/warning threshold is currently
no longer over/undershot
Alarm has been acknowledged
Alarm has not yet been acknowledged
