JPC 100-PRO
13
4.
Mounting
4. 1
Installation location
The device is suitable for installation in
stationary and weatherproof switchboards
indoors.
4. 2
Mounting orientation
The switchboard cut-out dimension is
252 mm + 1 mm x 174.5 mm + 1 mm
(9.92 in + 0.04 in x 6.87 in + 0.04 in) with a
wall thickness of at most 3 mm (0.12 in).
252 +1
174.5 +1
R3
Fig. 03: Cutout dimensions JPC 100-PRO
For sufficient ventilation, observe the mini-
mum distance of 20 mm (0.79 in) around the
circumference to adjacent assemblies (to all
sides and the back).
DANGER
Danger of electric shock!
Electric shocks lead to serious injuries,
including death.
•
Disconnect your system from the
power supply before mounting and
connecting the device!
•
Secure it against being switched on!
•
Check to be sure it is de-energized!
•
Ground and short circuit!
•
Cover or block off adjacent live parts!
•
The installation must only be carried
out by qualified personnel with electri-
cal training!
ATTENTION
Material damage due to disregard of the
mounting instructions.
Disregard of the installation instructions can
damage or destroy your device.
•
Observe the following description for
mounting and in particular the maxi-
mum tightening torque for the retaining
brackets of the device (see technical
data).
•
Provide adequate air circulation in your
installation environment and cooling,
as needed, when the ambient tempera-
tures are high. Follow the general ESD
protective measures.