Connection
To make a connection, strip about ¼in of insulation from the end, twist any loose strands toget-
her tightly so that no loose end sticks out to cause problems with short circuits. Make the
connection by unscrewing the binding post counterclockwise and exposing the wire hole. Insert
the stripped wire end into the wire hole and tighten the binding post by turning it clockwise.
Make sure the metal conductor contacts the stripped part of the wire, not the insulation, and
there are no loose strands to cause problem short circuits.
Observe polarity when making connections, making sure +(plus) goes to + (plus), - (minus) goes
to (minus) and that the channels are not crossed. Improper connections can cause the system
to be inoperative or less than optimum.
Following the same precautions, connect the speaker wires to the appropriate JSS4 terminals
marked output.
All manuals and user guides at all-guides.com
