JAMAR Technologies TRAX Totalizer, User Manual

Page: 12 / 32

TRAX Totalizer User’s Manual
2-2 2-3
Start-up Screens
When you power on the TRAX Totalizer, the counter will display several
screens with information on the current status of the unit. After the initial
sign on, the version number of the firmware is displayed.
This is followed by the number of days the counter is currently set to record
and the dead time (DT) setting.
*Note that if your counter is equipped for loops, you will also see the
loop sensitivity setting.
Next is listed the currently selected layout.
*Note that if your totalizer uses loops, or is only one input, this will
not be displayed.
IMPORTANT:
Totalizers that use loops for data collection will also au-
tomatically begin to tune themselves to the loops when they are turned on.
This process takes approximately 2 minutes. The Totalizer will not begin
to record data until the tuning process is complete.
After the start up screens have been displayed, the main menu will be
shown.
VERSION 1.0.00
D:00 DT:30ms S3
LAYOUT: A,B