User Manual (Ver. 1.0) - Preparation
GO-5000M-PMCL-1 | GO-5000M-PMCL-EP-1 | GO-5000M-PMCL-UV-1
- 17 -
Preparation
Read this section to learn how the camera connects to devices and accessories. The preparation
process is described below.
1
l
Connect the lens, Camera Link cable, AC adapter, computer, and other devices.
2
Step 2: Verify Camera Operation
l
Verify whether the camera is turned on and ready for use.
3
Step 3: Verify the Connection Between the Camera and PC
l
Verify whether the camera is properly recognized.
4
Step 4: Change the Camera Settings
l
Refer to the procedure for changing the output format setting as an example and change various
settings as necessary.
5
Step 5: Adjust the Image Quality
l
Refer to the procedures for adjusting the gain and black level as examples and adjust the image
quality.
6
l
Save the current setting configurations in user memory.
Short ASCII Commands
The most universal method for controlling a Camera Link camera such as this camera is by the use of
short ASCII commands sent via serial communications. All Camera Link frame grabber boards
support the use of these short ASCII commands. SDKs that utilize these ASCII commands for
developing machine vision applications are typically available from the grabber manufacturer, as well
as from third-party vendors.
This section describes how to configure various camera settings using serial communication and
specific short ASCII commands. A complete list of all available ASCII commands for this camera can
be found at the end of this manual (
).
This camera fully supports applications written using GenICam-based SDKs. The advantage of this is
that programs written using GenICam names can be applied with little or no modification to control
cameras with other GenICam-compliant interfaces and even GenICam-compliant cameras from
different vendors.
