GO-5000M-PGE-1 | GO-5000M-PGE-UV-1 | User Manual (Ver. 1.0)
Main Functions
- 52 -
Acquisition Start
This is the command to start the capture.
Acquisition Stop
This is the command to stop the capture.
Acquisition Frame Rate
With Trigger OFF, the default frame rate of the camera is based on the specified ROI. The smaller the
ROI, the faster the default frame rate. However, it is possible to specify a free-running frame rate (i.e.,
no trigger needed) that is slower than the default rate. This can be useful when a longer exposure time
is needed for a specific ROI.
Note:
If the PacketDelay (TransportLayerControl) setting is high, the number of output frames
may be thinned out. In this case, lower the AcquisitionFrameRate or lower the Packet Delay value
to acquire the required number of frames.
The setting range in Acquisition Frame Rate is:
Shortest
to
Longest
Inverse number of time required to drive all pixels in the area set by ROI command or
inverse number of time required to transmit one frame data
to
0.125 Hz (fps)
= 8 seconds
1. This function does not work when the trigger is set to On.
2. The set value is the frame frequency.
3. If attempting to set a frame rate higher than the maximum frequency, it will automatically be set
to the highest frequency that can be operated.
Free-running operation (Trigger = Off) operates in the following settings:
l
ExposureMode is set to Off
l
ExposureMode is set to Timed; TriggerMode(FrameStart) is set to Off
Note:
The acquisition frame rate may be limited to the maximum value which will fit within the
GigE bandwidth.
