JAI AD-131GE, User Manual

Page: 44 / 92

AD-131GE
43
10. Functions (Conforming to GenICam SFNC 1.3)

This section describes naming of GenICam SFNC ver.1.3.
AD-131GE uses the feature names specified in GenICam SFNC ver.1.3 but some functions are
not implemented. AD-131GE also provides feature names used in previous JAI cameras.
10.1. Acquisition function
Before using trigger and exposure controls, various acquisition controls must be set. The
operation of the camera depends on the interrelationship of all three feature sets.
Fig.31 Acquisition control, Trigger/Exposure control work flow
10.1.1 Basic image acquisition flow
The basic commands for acquiring images are as follows:
Acquisition mode
To determine the number of the frame to be captured
Trigger Selector
Acquisition Start Trigger
Select if the acquisition start is controlled
externally
Acquisition End
Select if the acquisition end is controlled externally
Trigger Selector Frame start
Select if the acquisition of the frame is controlled
externally.
Acquisition
State
Control
Exposure Control
Trigger
Selector
[Acquisition
Start]
Trigger
Selector
[Acquisition
Stop]
Trigger Mode
[JAI Acquisition
Transfer Start]
Acquisition Control
Active
Trigger / Exposure Control
Acquisition Start
Acquisition Stop
Acquisition Abort
Acquisition Mode
Acquisition Frame count
Trigger Selecctor
[Frame Start]
Trigger Selector
[Exposure Start]
Trigger Selector
[Exposure End]
Acquisition Frame Rate
Stream Control
Acquisition Status Control
Internal
Stream
Control
Acquisition
Status
Internal
Exposure
Control