JAI AD-131GE, User Manual

Page: 11 / 92

AD-131GE
10
4. Locations and functions
4.1. Locations and functions

CCD sensor : 1/3 inch CCD sensor

Lens Mount
: C-mount ( Note*1 )

12P Multi Connector
: DC+12V and Trigger Input

LED
: Power and Trigger indications

6P Multi Connector
: LVDS IN and TTL IN and OUT

RJ-45 Connector(GigE 1) : GigE Vision I/F w/ thumbscrews for color

RJ-45 Connector(GigE2)
: GigE Vision I/F w/ thumbscrews for NIR

Holes for RJ-45 thumbscrews : Vertical type (Note*2)

Holes for RJ-45 thumbscrews : Vertical type (Note *2)

Mounting holes
: M3, max length 5mm (Note*3)
*
1) : AD-131GE uses prism optics. For optimal performance, C-mount lenses should be designed for
interfacing to a 3CCD camera. Rear protrusion of the C-mount lens must be less than 4mm
to avoid damage to the prism.
*2) : When an RJ-45 cable with thumbscrews is connected to the camera, please do not excessively
tighten screws by using a screw driver. The RJ-45 receptacle on the camera might be
damaged. For security, the strength to tighten screws is less than 0.147 Newton meter (Nm).
Tightening by hand is sufficient in order to achieve this.
*3) : The tripod adapter plate MP-41 can be used with AD-131GE
Fig.1 Locations