ELSEMA
Enter the world of wireless
GLR2702/GLR43302 GIGALINK
™
RECEIVER SETUP INSTRUCTIONS
The transmitter/receiver can be single or channelised code programmed.
Single Code Programming
This is used for programming one channel at a time to the transmitter. Single code programming can be
achieved by following the steps below:
Step 1:
Connect power to the GIGALINK
™
receiver.
Make sure all switches on the mode dipswitch
are off
.
Step 2:
Momentarily short the two CC pins on the receiver board. (This sets all the channels to a
random code. If there are transmitters previously programmed, they will have to be re-
programmed when CC pins are shorted.)
Step 3:
Select the receiver channel, to be programmed, by setting the 2-way dip switch. See dip switch
table below.
Dip Switch
Setting
Receiver Channel
(Output Relay)
Receiver Type
1
2
Off
Off
1
GLR2702/GLR43302
On
Off
2
GLR2702/GLR43302
Step 4:
Connect the transmitter to the receiver by inserting the GIGALINK
™
cable into the transmitter
and receiver 2.5-mm socket. (This will activate the programming mode and is indicated by the
red light (LED) on the transmitter that must remain “on”)
Step 5:
Activate one of the selected channels on the transmitter for approximately one second, LED
should blink twice to confirm code programming and then switch “off”.
Step 6: Disconnect
GIGALINK
™
cable.
Repeat steps 3 to 6 to program another transmitter channel.
Channelised Code Programming
This is used to program all channels from a multi channel receiver to a multi channel transmitter. Channelised
code programming can be achieved by following the steps below:
Step 1:
Connect power to the GIGALINK
™
receiver.
Make sure all switches on the mode dipswitch
are off
.
Step 2:
Momentarily short the two CC pins on the receiver board. (This sets all the channels to a
random code. If there are transmitters previously programmed, they will have to be re-
programmed when CC pins are shorted.)
Step 3:
Connect the multi channel transmitter to the multi channel receiver by inserting the
GIGALINK
™
cable into the transmitter and receiver 2.5-mm socket. (This will activate the
programming mode and is indicated by the red light (LED), on the transmitter that must remain
“on”)
Step 4:
Press any two channels simultaneously on the multi channel transmitter for one second, LED
should blink twice to confirm code programming and then switch “off”.
Step 5: Disconnect
GIGALINK
™
cable.
Repeat steps 3 to 5 to program another multi channel transmitter.