JBE-P2L1 Panel Manual V1.2 EN
Page 35
Release Date: January 5, 2021
Rev 01
5.6.1.10 Setup printer
The printer is an optional accessory to the panel. If the user doesn’t require or need the additional printer
box, in that case the printer configuration is not necessary. When the user chooses to add the additional
printer box, the installer needs to configure the printer upon installation. Change the status (either On or
OFF) by pressing F3 to switch on the printer. Under “current mode”, either “dense” (F4) or “spaced” (F5) can
be selected to change the spacing between the characters.
5.6.2 Install Menu
Under this menu, users can operate all the tasks related to the system set up such as set password and
language, operate auto-registration of the panel, update the USB firmware and configurate the system and
so on. To enter the install menu, the 10-digit password from access level 3 is required. By pressing the
Home key and then the F5, user can navigate the install menu by using both alphanumeric keypad and
function keys.
The sub-menu choices from the Install menu is as follows:
1.
Wizard
2.
Auto-Registration
3.
Set Password
4.
Set language
5.
Set special operation mode
6.
Enter advanced programming
7.
Clear
8.
System configuration
5.6.2.1 Wizard
From the sub-menu wizard, user can operate tasks such as install wizard or maintain wizard. After entering
the sub-menu install wizard, user can operate the tasks available from the listed function of: Auto
Registration, assign devices to zones, set address descriptions, Assign devices to activation group or set
the password.
In the sub-menu maintenance wizard, user can view the event log, perform the keyboard test, perform the
indicator test, test an output group or test zones.
5.6.2.2 Auto-registration
From this submenu, users can automatically register devices by entering the loop to which the designated
devices belong. After automatic device registration is complete, the interface will automatically switch to the
main screen.
5.6.2.3 Set password
From this sub-menu, users can change/setup both the operator and installer password.
5.6.2.4 Set language
From this sub-menu, users can select the system language from the list of languages available on the panel.