Jadak Photo Research SpectraScan PR-7 Series, User Manual

Page: 138 / 142

Appendix 1
– Remote Control Mode
134
R
EMOTE
C
ONTROL
E
RROR
C
ODES
R
EMOTE
C
ONTROL
M
EASUREMENT
E
RRORS
Error Meaning
-0001 Light source not constant.
-0002 Light overload
– signal too intense.
-0003 Cannot Sync to light source. Light source frequency below 20Hz, above 400
Hz or signal too low to Sync.
-0004 Adaptive mode error.
-0008 Weak light
– insufficient signal.
-0009 Sync Error.
-0010 Cannot Auto Sync to light source.
-0012 Adaptive mode time out. Light source not constant.
R
EMOTE
C
ONTROL
P
ARSING
E
RRORS
Error Meaning Valid Values
-1000 Illegal command
-1001 Too many fields in setup command
-1002 Invalid primary accessory code
-1003 Invalid Addon 1 accessory code
-1004 Invalid Addon 2 accessory code
-1005 Accessory is not a primary accessory
-1006 Accessory is not an Addon accessory
-1007 Accessory already selected
-1008 Invalid Aperture index (PR-7XX only)
-1009 Invalid units code
0 = English
1 = Metric (SI)
-1010 Invalid Exposure value
3 to 6000 ms
PR-7XX
6 to 30,000 ms
-1011 Invalid Gain code
0 = Normal
1 = 1X for AC sources
2 = 10X
3 = 100X
-1012 Invalid average cycles 1 to 99
-1013 Invalid Calc Mode
-1014 Invalid Trigger Mode
-1015 Invalid CIE observer 2 or 10