Page 16
9.0 Operating Instructions
The spa control system has automatic functions that operate
upon start-up and normal operation to protect the system.
Upon power up, the readout displays the following information:
1. Control panel displays current software release (e.g. 3.52),
then;
2. Control panel displays “888” and all indicator LEDs are
lit, permitting visual inspection of all display segments
and indicator lights for proper operation.
3. After the initial start-up sequence ends, the actual water temperature is
displayed. If water temperature at this time is less then the factory
default temperature setting of 100 °F (38 °C) and the spa is set to
either standard filtration mode “F0-F3”, the heater will turn on and run
until the water temperature rises to the factory setting, then turn off.
Note: it is common for the heater to turn on after the spa is first filled
because tap water is often very cold.
9.1 Setting Water Temperature
The spa’s thermostat provides optimum control of water
temperature. The temperature setpoint (set temperature)
can be adjusted from 65 °F to 104 °F (18 °C to 40 °C). To
raise the set temperature, press the
WARMER ( + )
button. To lower the set temperature, press the
COOLER
( - )
button.
Note: The first press of either
WARMER ( + )
or
COOLER ( - )
button displays the set temperature.
9.2 Activate Pumps
The
JETS 1
button activates the functions of the main
2-speed jets pump. The first press activates pump 1 in low
speed, the second press activates high speed, and the
third press shuts the pump off. The
JETS 2
button controls
jets pump 2 which only operates in high speed. Both pumps
have a twenty-minute default when manually activated.
9.3 Light Button
The
LIGHT
button activates the spa light when pressed.
The light has a one-hour default.
9.4 Selecting Desired Massage Action
Your Jacuzzi Premium spa is equipped to allow you to customize the
massage action you desire. Each model incorporates a diverter valve that
1.
2.
3.
