12
B.
Resetting the duration countdown timer (
CLEAR
RAY System only)
Once the duration countdown timer for the CLEAR
RAY
System has reached zero, you will need to reset it,
replace the UV bulb and clean the quartz tube.
To reset the duration countdown timer:
1. Press and hold the
Jets pump 1
( ) and
Cooler
(
) button
at the
same time
for 3 seconds.
2. Press the
Warmer
(
) button until the display shows “0.”
3. If the timer has reached “0,” pressing the
Jets pump 1
( ) button will reset it.
If the timer is not at “0”
pressing the Jets pump 1 button will not reset it.
Note:
If the spa power is interrupted, the duration countdown timer is not affected. The number of days remain-
ing is stored in the memory and will continue to countdown once power is regained.
4. If the duration countdown timer is not at “0” and you need to reset it:
a. Press and hold the Jets pump 1 and Cooler buttons at the same time for 3 seconds.
b. Press the Warmer button to scroll to “U.”
c. Press the Jets pump 1 button to switch from “U” to “O3.”
d. Press and hold the Jets pump 1 and Cooler buttons at the same time for 3 seconds.
e. Press the Warmer button to scroll to “O3.”
f. Press the Jets pump 1 button to switch from “O3” to “U.” The timer has been reset to 365 days.
4.9 2011 Aftermarket Ozonator Facts
Ozone System Specifications are:
J-LX Ozone System Specifications
• Circulation pump and ozone run 8 hours. Cycle starts approximately two minutes after power up.
• Ozonator shuts off when either JETS button is pressed. The Ozonator will resume operation approximately
5 minutes after jets are turned off intentionally or automatically. The ozonator also shuts off if the hot tub
goes into “summer logic.” See Section 5.4 (page 14).
• Pressing a JETS button during an active filter cycle cancels the filter cycle until the next term.
Note:
Pump may stay on if a heat call is present.
J300 Ozone System Specifications (All
2011-2013 models)
J200 Ozone System Specifications (J-270, J-280, and J-230 models with a Circulation Pump)
• Circulation pump and ozone run 24 hrs.
• Ozonator shuts off when either JETS button is pressed. The Ozonator will resume operation approximately
5 minutes after jets are turned off intentionally or automatically. The ozonator also shuts if the hot tub goes
into “summer logic.” See Section 5.4 (page 14).
• Pressing a JETS button during an active filter cycle cancels the filter cycle until the next term.
Note:
Pump may stay on if a heat call is present.
J200 Ozone System Specifications (Models without Circulation Pump)
• Ozonator runs during a programmed filter cycle.
• Ozonator turns off when either JETS button is pressed and will resume operation approximately 5 minutes
after jets are turned off intentionally or automatically.
• Pressing a JETS button during an active filter cycle cancels the filter cycle until the next term.
Note:
Pump may stay on if a heat call is present.
Press
Press
1
