Page 88
J-400
17.0 Error/Display Messages
There are a number of unique functions designed into
your Jacuzzi spa to protect it from damage and/or to aid
in troubleshooting. When an error occurs the spa will
notify you by showing the screen below and an error code next to it. Also
the indicator light located on the front cabinet panel of the spa is an early
detection system that will notify you when the spa needs immediate
attention. A solid white light indicates that all operations are normal. A
solid red light indicates that immediate attention is required to clear or fix
an error code. Following is a listing of all the possible messages along
with their meanings.
Always insist on genuine Jacuzzi replacement
parts.
1. Overheat protection: (Heater is deactivated, filter/circulation pump is
activated). Water temperature is above acceptable limits.
DO NOT
ENTER THE WATER!
Remove spa cover to speed cooling. See
“Water Is Too Hot” on page 93. If condition persists, contact your
authorized dealer or authorized service center.
2. Water is below set-temp: If the spa water is more than 20°F/6°C
cooler than the temperature set point, the circulation pump and
heater will automatically activate to provide freeze protection. The
spa will stay in this mode until the water temperature reaches
15 degrees below the set temperature. No corrective action is
necessary.
Error
Logo
Light
Error
Logo
Light
Overheat Protection
Red
Shorted Sensor (Hi-Limit)
Red
Water is below set-temp
White
Start-up Malfunction
Red
Communication Error
Red
Open Flow Switch
Red
Pump does not operate
Red
Closed Flow Switch
Red
Freeze Protection
White
Audio Comm. Malfunction
White
Emergency Shutdown
Red
Blinking Heater Icon
White
Open Sensor
Red
Extended Temp Activated
White
Shorted Sensor
Red
Please Check Filter
White
Open Sensor (Hi-Limit)
Red
Feature Not Installed
White
98
F
Temp.
4:05 PM
!
“Displays
Error
Message”
WARNING:
RISK OF HYPERTHERMIA (OVER-HEAT-
ING) CAUSING SEVERE INJURY, BURNS, OR WELTS.
!
