Page 62
J-400
12.1 Programming the Eco-Mode Heating Mode
Eco-Mode is an energy saving heating program. By heating the spa in
the non-peak hours, you conserve electricity. While in Eco-Mode the spa
is programmed to heat during the hours of 5:00 PM to 7:00 AM on a daily
basis. The functions for this mode cannot be altered.
To access the Eco-Mode Submenu:
1. From the “Settings 1” menu (Figure
A), press button A to enter the
Heating programs. The menu
appears with Eco-Mode selected. The
display will change to Figure B.
2. If you elect to use this mode, press
the Splash button on the Quad
Keypad. The display will confirm
your selection and Figure C will be
displayed briefly then return to the
Heating submenu.
3. To exit the submenu, press button D
to return to the Settings 1 menu.
4. If you have programmed the Eco-Mode cycle you will see
the Eco-Mode Icon (
ENERGY EFFICIENT
) next to word “Heating” on the display
(Figure A).
12.2 Programming the Auto-Heating Mode
Auto-Heating mode is typically selected
by customers in cold climates where heat
up times are extended due to lower
ambient temperatures. In this mode,
water temperature is regulated by the set
temperature which activates the heater
automatically as needed.
Note:
If you elect to use Auto-Heating,
you can skip this section. Auto-Heating is the default spa
setting.
1. Press button B to enter the Heating
Menu (Figure D). Use the Quad
Keypad to down button to select
Auto-Heating.
2. If you elect to use this mode, press
the Splash button on the Quad
Keypad. The display will confirm your
selection and Figure E will be displayed briefly then return
to the Heating submenu.
ECO-MODE
Eco-Mode Enabled
ENERGY EFFICIENT
HEATING
Press to Save
Select
Programmable
Auto-Heating
ENERGY EFFICIENT
2
Eco-Mode
Figure B
Figure C
HEATING
Press to Save
Select
Programmable
Auto-Heating
2
Eco-Mode
ENERGY EFFICIENT
Figure D
24-hour Heating
Enabled
AUTO-HEATING
Figure E
