Page 67
J-400 Series
20.8
Generic mP3 Player Operation
1.
Connecting Your mP3 Player
A. The Audio unit is equipped with
an auxiliary audio input jack, that
allows the user to listen to external
source, such as an MP3 Player.
2.
setting up The mP3 Player for use
A.
Select preferred song/album/
playlist prior to plugging in MP3
player and start playback.
B. Press “Mode Button” on stereo
receiver until the LCD display
reads “
auX
”.
note:
All external MP3 player playback operations are performed solely
by the MP3 Player with the exception of volume control and “Mode
Button” selector, which can be controlled via wireless remote or on the
stereo receiver.
warnInG:
rIsK OF eleCTrICal sHOCK HaZarD
eXIsTs anD eQuIPmenT DamaGe!
Never connect,
disconnect or operate external MP3 player while hands are
wet or while sitting or standing partially or fully immersed in
water!
20.9
J-1000™ audio system stereo Troubleshooting
1.
unit will not turn-on
Make sure spa power is turned on,
then check harness fuse on side of unit
making sure they are the proper ratings:
Yellow memory B+ line (10A fuse).
•
When faced with a malfunction during
•
operation, push BND button (8) and EJ
button (13) at the same time to reset
software.
Using a thin rod to press the reset button
•
located besides the USB docking station to do a hardware reset.
note:
It will be necessary to re-enter the radio preset memories and
other personal settings after perf
orming a reset. After resetting player,
always ensure all functions are operating correctly.
1
2
17
3
9
8
7
5
4
6
10
11
13
15
12
16
14
USB
