J-200 Series
only while a programmed filtration/heating cycle is running.
Note: these modes
can be used to conserve energy while on vacation or out of town for several weeks
since heater operation is minimized. During such times, you can also minimize
the spa set temperature to maximize energy savings!
11.4 Lock Modes - L1-L2 (All Models)
These modes are designed for use during spa service or to prevent unauthorized
use.
11.5 Selecting The Filtration/Heating Mode
Press and hold both control panel WARMER (
) and COOLER (
) buttons at
the same time, then release. Then press either WARMER (
) or COOLER (
)
button to select either filtration/heating mode or lock mode as outlined below.
11.6 Filtration Modes for Spas Without Circulation Pump Option (All
Models)
If your spa is equipped with the circulation pump option, disregard this section
and refer to page
for filter cycle programming details.
Standard Filtration/Heating Modes (F1-F3)
(Heater automatically turns on during any heat call while in any Standard
mode).
F1
4 hours of filtration/heating per day (one 2-hour cycle every
12 hours).
F2
6 hours of filtration/heating per day (one 2-hour cycle every
8 hours).
F3
8 hours of filtration/heating per day (one 2-hour cycle every
6 hours)
Economy Filtration/Heating Modes (F4-F6)
(Heater can only turn on during an active filter cycle while in any economy
mode).
F4
4 hours of filtration/heating per day (one 2-hour cycle every
12 hours).
F5
6 hours of filtration/heating per day (one 2-hour cycle every
8 hours).
F6
8 hours of filtration/heating per day (one 2-hour cycle every
6 hours)
Lock Modes (L1-L2)
L1
Lock Out (disables all spa functions to permit filter
cleaning)
L2
Lock Mode (disables the jets and light buttons to prevent
unauthorized use of spa). Filtration/heating cycle will
continue to operate as programmed in this mode. The tem-
25
