8
TRACTOR
CAB
ASSEMBLY INSTRUCTIONS
11. From the left side of the tractor, install the “S”
hook on the top edge of the pump mount plate
as shown in Drawing C.
12. Stretch each top elastic cord from the fabric
panel across the front panel to the extended
bolts. Pull the middle elastic cord through the
tractor above the drive shaft. Loop the elastic
cord over the “S” hook to prevent rubbing the
driveshaft. Take the bottom elastic cord through
to the other side in front of the frame pivot as
shown Photo 4.
13. Mount the wiper above the windshield according
to the wiper instructions. Mount the wiper blade
on the wiper arm with the short end of the blade
away from the wiper motor. Check the wiper
blade path so that it does not contact the rubber
moulding. Fasten the inline fuse to the auxiliary
side of the circuit breaker and route the wire to
the wiper.
14. On Kubota engine models, install the air intake
tube guard on the left rear of the black side
panel. The guard bolts to the same holes that
the side panel does and uses the existing
hardware. The guard is to prevent the cab
fabric from plugging the air intake tube and
stalling the engine.
Drawing C
Photo 4
(420 is shown.......430 is similar)