5
LOADER
LD300
INSTALLATION INSTRUCTIONS
MOUNTING INSTRUCTIONS
1.
Install mounting shaft through tractor frame and secure with bolt. Place clamp over each end of shaft.
2.
Drive tractor carefully into position until the front lift latches.
3.
Raise tractor front lift to tilt loader onto mounting shaft.
4.
Place clamps in position and tighten.
5.
Install pump drive belt.
6.
Install weight bar and 6 weights.
REMOVAL INSTRUCTIONS
1.
Raise bucket approximately 20" from the floor.
2.
Loosen clamps to mounting shaft.
3.
Stop engine and remove pump drive belt.
4.
Carefully lower tractor front lift, allowing loader to tip forward until bucket rests on floor.
5.
Release quick attach and carefully back tractor away from loader.
6.
Block or support frame of loader in case of accidental movement of control levers which will affect the
position of the loader for re-mounting.
7.
Remove mounting shaft if desired.
8.
Remove weights from weight bar.
