6 MAINTENANCE & LUBRICATION CHARTS
en-24
6
MAINTENANCE & LUBRICATION CHARTS
6.1 GENERAL ________________________________________________________________
1. Always clean the grease fitting before and a fter
lubricating.
2. Lubricate with grease that meets or exceeds NLGI
Grade 2 LB specifications. Apply grease with a
manual grease gun and fill slowly until grease begins
to seep out. Do not use compressed air guns.
3. Periodically apply a sm all amount of li thium based
grease to the seat runners.
4. For smooth operation of al l levers, pivot points and
other friction points that are not shown on th e
lubrication chart apply several drops of SAE 30 oil
every 40 hours or as required.
5. Grease fittings every 40 hours.
6.2
LUBRICATION CHART______________________________________________________
WARNING
Before you clean, adjust, or repair this equipment
disengage all drives, lower implements to the ground,
engage parking brake, stop engine, and remove key
from ignition switch to prevent injuries.
!
A
- Steering Axle Pivot
B
- Steering Spindle Pivot (2)
C
- Steering Cylinder (2)
D
- Tie Rod (2)
A
B
B
C
C
D
D
