3 CONTROLS
GB-9
3.3
CONTROL PANEL _________________________________________________________
Figure 3B
O. Low Oil Level Switch
This switch is used to test the alarm system or
disable the alarm after a low oil level has been
detected. Keep switch in its ON position when
starting and operating tractor. To test alarm, set switch
to OFF and turn ignition key to RUN. See Section 3.4.
P.
Mower Lift lever
The mower lever raises and lowers the mowers and
operates in either automatic or manual mode. Push
lever forward to lower mowers, pull back to raise
mowers.
Manual Mode - Set mow switch (Q) in its OFF (down)
position. In this position all mowers will raise or lower
while pressure is applied to the lift lever.
Automatic Mode - Set mow switch (Q) in its ON (up)
position. In automatic mode the mowers will lower and
start automatically with a momentary forward movement
of the lift lever. In this mode mowers will only raise to a
“crosscut” position with a momentary backward
movement of the lift lever.
To raise mowers to their transport position, hold lever
until mowers are fully raised.
To raise mowers to their transport position, hold lever
until mowers are fully raised.
NOTE: While in an Automatic Mode lift or lower cycle,
that lasts approximately 3 seconds, moving the lift lever
in the opposite direction will turn all mowers off and
manual mode will start for the position selected.
Q. Reel Switch
The reel switch is a 2-position knob type switch used to
turns the mowers On or off. It also sets the mower lift
lever (P) in manual or automatic mode. Set mower
switch in its OFF (down) position when starting the
tractor.
R. 2 WD / 4 WD Switch
Sets tractor into two or four wheel drive.
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
