MAINTENANCE AND LUBRICATION 8
en-59
8.5
ENGINE COOLANT ________________________________________________________
Check coolant level each day. The radiator must be full and the expansion tank must be at the cold mark.
Drain and fill the cooling system each year. Empty and clean the expansion tank.
Mix clean water with anti-freeze for the coldest ambient temperature. Read and follow the instructions on the anti-
freeze container and the Engine manual.
Keep the radiator and hydraulic oil cooler air passages clean. Do not use water to clean the fins. Only use low pressure
compressed air to clean radiator.
Check and tighten the engine fan belt (see maintenance chart) and replace the belt (see maintenance chart). Replace
the clamps and hoses (see maintenance chart).
Have your Jacobsen Dealer check the cooling system if you need to add coolant more than one time a month or you
add more than a liter of coolant at a time.
WARNING
To prevent injury from the hot-engine coolant or steam, never remove the expansion tank cap with the engine
in operation. Stop the engine and wait until the radiator is cool. When radiator is cool, use caution to remove
the expansion tank cap.
CAUTION
Do not put cold coolant mixture into a hot radiator. Do not operate the engine without a correct coolant
mixture. Install the radiator cap correctly.
CAUTION
Stop engine and remove the key before pressure washing. Do not use a pressure washer near the instrument
panel or engine radiator to prevent damage.
!
!
!
Summary of Contents for 672256G01
Page 96: ......
Page 97: ...SPECIFICATIONS 12 en 95...
