3
option
: The telephone can be equipped with a SANIK .4V
650mAh Ni-MH battery, model SN-AAA65H-S-J1. which
enables the telephone to operate for a short period in case
of power failure. The battery is optional and not included.
Caution
Risk of explosion if the battery is replaced by an
incorrect type. Use only the SANIK .4V 650mAh Ni-MH
rechargeable battery pack, model SN-AAA65H-S-J1.
Contact your local supplier for the back-up rechargeable
battery.
You must disconnect the power supply unit and the
telephone line cord before installing the back-up
battery.
Do not dispose of the battery in fire. It may explode.
Dispose of used batteries according to the instructions.
Use only the Ktec Model
KSlfb0750035W1eu (for the
european market except uK) / KSlfb0750035W1uK
(for the uK market)
power adaptor with red RJ11 plug
that came with the unit. Using other power adaptors
may damage the unit and invalidate your warranty.
Plug the adaptor to a socket outlet that is close to the
equipment and easily accessible.
1. Install the back-up battery (optional) following the
procedure in section A.4.
. Connect one end of the coiled cord to the handset and
plug the other end into the RJ9 jack of the base station.
note:
If desktop placement is preferred, please mount the
table stand first.
3. Connect the combo cord to the RJ45 jack of the combo
jack. Connect the line jack to the RJ11 line jack on the
base (16) and connect the DC jack to the base (17).
4. Plug the power supply unit into the main wall outlet and
connect the other end to the RED jack of the combo jack.
5. Connect one end of the telephone line cord to the
BLACK jack of the combo jack; connect the other end of
the telephone line cord to the country telephone plug
adaptor (optional).
6. Connect the country telephone plug adaptor to the wall
outlet for telephone.
•
•
•
•
•
A .1 . Wall mounting
1. Pull the Combo cord downwards through the groove
(as shown above) in order to let it out at the bottom and
connect it to the Combo jack.
. Mount the base station by the enclosed screws and plugs
for 6 mm drill.
A .2 . desktop placement - table stand
Slide the canals of the table stand into the tracks of the back
side on the base station. The table stand is mounted when
you hear a click.
The table stand can easily be removed again:
- Push the button inside the square hole at the bottom
of the base station, using a pen or a finger, and pull the
bracket away from the base station at the same time.
