Jackson Labs RSR GNSS Transcoder, User Manual

Page: 64 / 128

RSR GNSS Transcoder™ User Manual
54 © 2017 Jackson Labs Technologies, Inc.
where <prn> is the satellite PRN number 1 to 32 or 0 for none. This parameter is stored in NV
memory and automatically applied after power-on.
4.3.28 SIMulation:SV?
This query command will output the query results from the following queries:
SIM:SV:EXCL?
SIM:SV:MASK?
SIM:SV:TRAC?
4.3.29 SIMulation:TIME:MODE
This command sets the simulation Time mode when running in Simulation mode. When using the
ASSIGNED time mode, the simulation will always start with the time and date assigned with the
SIM:TIME:START... commands.
When using the CONTINUOUS time mode, the simulation will use the current time provided by an
external GNSS receiver or UTC time manually set with the PTIME... commands. If the current time
has not been set, then the time will be set to the value set by the SIM:TIME:START... commands at
the begining of first simulation run. If the simulation is stopped and started again the selected set time
will be propgated by the local receiver.
The format of this command is:
SIMulation:TIME:MODE <ASSIGNed | CONTinuous>
This parameter is stored in NV memory and automatically applied after power-on.
4.3.30 SIMulation:TIME:START:TIME
This command sets the fixed UTC start time used in the simulation when the simulation Time mode
is set to Fixed. The GPS receiver will indicate the this time when the simulation begins. This
parameter is stored in NV memory and automatically applied after power-on.
The format of this command is:
SIMulation:TIME:START:TIME hh,mm,ss.sss
4.3.31 SIMulation:TIME:START:DATE
This command sets the fixed start date of the simulation when in the simulation Time mode is set to
Fixed. The GPS receiver will indicate the this time when the simulation begins. This parameter is
stored in NV memory and automatically applied after power-on.
The format of this command is:
SIMulation:TIME:START:DATE yyyy,mm,dd