Jack-it 204002 Installation Instructions Download Page 1

 

Page 1 of 2 

      3/31/09 Rev3(DP) 

 

 

 

 
 
PARTS LIST: 

 

Driver/Left Sidebar 

4  12mm x 60mm  Hex Head Bolts 

Passenger/Right Sidebar 

4  12 mm Lock Washers 

Driver/Left Front Mounting Bracket 

4  12mm x 30mm OD Flat Washers 

Passenger/Right Front Mounting Bracket 

 

 

Driver/Left Rear Mounting Bracket 

4  14mm x 140mm hex head bolts 

Passenger/Right Rear Mounting Bracket 

4  14mm lock washers 

 

 

4   14mm x 45OD flat washer 

 

 

 

 

 
 
PROCEDURE: 

1.  REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ 

INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.  

2. 

Starting on the driver side, remove the factory front body mount bolt from the underside of the 
cab. 

NOTE: 

Factory body mount bolts will need to be driven out of and back into the steel 

washer molded into the rubber bushing.   Aries has supplied 14MM hardware to replace 
existing bushing hardware if needed.  

 

3. 

Locate the driver side front Mounting Bracket and bolt it to the vehicle using the factory body 
mount bolt or 14MM hardware, 

(Figure 2)

NOTE:

 Brackets mount over bushings. Do not 

tighten at this time.

 

4. 

Locate the driver side rear Mounting Bracket and bolt it to the vehicle using the factory body 
mount bolts, 

(Figure 5)

NOTE:

 Brackets mount over bushings. Refer to Step 2 for installation 

instructions.

 

5. 

Carefully position the driver Sidebar up to the Mounting Brackets. Use the included (2) 12MM 
Hex Head Bolts, (2) 12MM Lock Washers, and (2) 12MM Flat Washers to attach the Sidebar to 
the Mounting Brackets, 

(Figure 7 & 8)

.

 

6. 

Adjust the Sidebar properly and then tighten all hardware.

 

7. 

Repeat steps 2 – 6 for passenger Sidebar installation.

 

8. 

Do periodic inspections of the installation to make sure that all hardware is secure and tight.

 

 

To protect your investment

, wax this product after installing. Regular waxing is recommended to 

add a protective layer over the finish. Do not use any type of polish or wax that may contain abrasives 
that could damage the finish.  

 

For stainless steel

: Aluminum polish may be used to polish small scratches and scuffs on the finish. 

Mild soap may be used also to clean the Sidebar. 

For gloss black finishes

: Mild soap may be used to clean the Sidebar

 

 

 
 
 

INSTALLATION INSTRUCTIONS 

204002/204002-2 

3” SIDEBAR WITH BENT END 

04-10 CHEVY COLORADO/ GMC CANYON EXT CAB 

Reviews: