Thank you for purchasing an interSeptor sensor
Please use the following instructions to install the sensor
Sensor Installation Instructions
Temperature / Temperature & Humidity
Sensors
The temperature sensor and/or temperature / humidity sensor should be connected to the
interSeptor using the supplied black cable. Once you have located the sensor, plug one end
of the cable into the RJ45 socket of the device and the other end into one of the two “EMD”
ports on the rear panel of the interSeptor. The interSeptor will then auto-detect the presence
of the device. The high / low thresholds and the hysteresis level for the sensors can be
configured via the web browser interface.
GoProbe! Sensors
The GoProbe! sensors (security, voltage, water leak detection, dry contact, PIR, vibration and
smoke) should be attached to the interSeptor via the GoProbe! alarm sockets on the
temperature and temperature / humidity sensors. The sensor contacts should be inserted and
screwed into either the left pair (first alarm) or right pair (second alarm) of GoProbe! sockets.
Security Sensor
The relevant alarm should be configured in the browser (through the EMD-1 or EMD-2 setup
screens) to be either “Normal Close” or “Normal Open”, depending on the sensors
deployment.
Voltage Sensor / PIR Sensor / Vibration Sensor
The relevant alarm should be configured in the browser (through the EMD-1 or EMD-2 setup
screens) to be “Normal Close”. When power is lost, movement detected or vibration sensed
the alarm will become ‘Active’.
NOTE: The LED on the voltage detector does not indicate status and should therefore be
ignored.
Water Leak Detector
The relevant alarm should be configured in the browser (through the EMD-1 or EMD-2 setup
screens) to be “Normal Open”.
When water is detected along the sensor cable the interSeptor will be activated.
Please follow these instructions to install the leak detection system:
1. Lay out the sensor cable in its intended location, taking care to keep it free from oil
and grease and away from metal surfaces.
2. Fix the sensor cable using the cable clips. Please take care not to damage the sensor
cable when fixing the clips. DO NOT CUT OFF ANY SURPLUS CABLE. When fixing
cable clips, wear eye protection as hardened steel nails can fracture when hit.
3. To test the system, drip a small quantity of water onto the sensor cable. The
interSeptor alarm will activate within 10 seconds. Allow the cable to dry completely for
the alarm to deactivate.
