ELECTRIC BILGE PUMPS
FEATURES
• Self-Priming
• Diaphragm Design Allows Dry Running
• Quiet Operation
• Built-in Hydraulic Pulsation Dampener
• Permanently Lubricated Ball Bearings on Shaft
and Connecting Rod
• Large Vibration Absorbing Pads
• Corrosion Resistant Materials Throughout for
Sea Water Service
• Meets USCG Regulation 183.410 and
ISO 8846 MARINE for Ignition Protection
SPECIFICATIONS
Open Flow:
8.0 GPM
Vert. Dry Suction Lift: 10 feet (3 m)
Ports:
3/4" Slip-on Hose
Weight:
11 lb
APPLICATION
Jabsco diaphragm bilge pumps are self-priming, so they
can be mounted above and outside of harsh bilge envi-
ronments. Because they are mounted remotely, the
intake hose can be routed to the lowest point of the bilge
regardless of space limitations. They are supplied with
an in-line strainer to prevent damaging debris from
entering pump. The reliable diaphragm design is not
damaged by dry running.
INSTALLATION
MOUNTING
Mount upright in a dry location (above highest bilge
water level) on a solid surface. Adjust belt tension for
1/4" play between pulleys.
PLUMBING
For intake and discharge use 3/4" ID non-collapsible
hose. Keep intake and discharge lines free of kinks and
restrictions. Use the 3/4" bilge in-line stainer (Model
36200-0000) in the intake line from the bilge to protect
pump from debris. Use a 3/4" thru-hull fitting for dis-
charge.
WIRING FOR DC VOLTAGE MODELS:
Wire pump in a circuit independent of all other electrical
fixtures. Use stranded copper wire. Install fuse/breaker
in positive circuit. See table for recommended wire and
fuse size. See diagram for wiring connections. Use a 10
amp-rated switch 44960-0000. After installation, it is rec-
ommended that voltage be checked at the motor termi-
nals with motor operating under full load and all other
appliances in the circuit operating. Voltage should not be
less than 90% of rated motor voltage.
STANDARD MODELS
Amperage
Model Voltage
Nominal
36600-0000
12 Vdc
11.0
36600-0010
24 Vdc
5.5
36600-0031
115 Vac
1.0
Model 36600-Series
Model 36600-Series
