3.2 Disarming
On the keypad
-
enter your user code
On the remote control
(RC-4x) – press the button
•
system will beep twice
•
if there are 3 beeps, important information is indicated and will
be displayed on the keypad. Examples:
o
FAILURE
LED is flashing – press the N key to view the cause
o
ALARM
LED and zone number is flashing = alarm in the memory.
Be careful and check the house.
•
if you enter the premises when the system is armed, the entrance delay
countdown will start after you trigger a delayed detector (ARM LED will
flash and beeps will sound if programmed so
*
).
3.3 Panic Alarm
If you are in danger you can trigger the silent panic alarm to inconspicuously call
for help. While in Panic alarm mode the control panel can send a voice message,
an SMS message and data to a central monitoring station via a telephone line
(depends on installation settings).
Panic alarm can be triggered:
•
On the keypad
- press the panic key and then enter your
access code.
On the remote control
(RC-4x) - press the and buttons
simultaneously. The remote control can be switched (by installer) to a
Panic mode, in which pressing of any button will trigger the Panic alarm.
•
By
pressing this large sized panic button, the
RC-22 (can be installed
on the wall, under a desk etc.).
3.4 To stop ALARM
If an alarm is triggered when you are present, you can
stop it by entering your access
code or by pressing button on the remote control
.
•
Sending of voice and SMS messages will cease after the alarm is stopped. All
corresponding report codes (alarm triggering & stopping) will be sent to the
central monitoring station.
•
If user does not stop the alarm, it will stop automatically after the programmed
period and the alarm memory indicator will activate. The control panel will
return to the same mode as before the alarm.
Alarm system JA-63 „Profi“
- 6 -
MGK51504
Summary of Contents for Profi
Page 1: ...JA 63 Profi User manual...
